Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screw (D1) and gasket (E1) from the xture.
4. Remove the mounting screw (C1) from the xture back plate.
5. Secure the mounting plate to the junction box using junction box screws (B1). The side of the mounting back plate marked “GND”
must face out.
CONNECTING THE WIRES (Fig. 2)
6. Connect the xture wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1, 3)
7. Secure the xture back plate to the mounting
plate with mounting screw (C1).
8. Place the xture on the xture back plate, and
secure it with mounting screw (D1) and gasket (E1).
9. To prevent moisture from entering the outlet box
and causing a short, use clear caulking
(i.e. indoor/outdoor silicone sealant) to outline
the outside of xture back plate where it meets
the wall. Leave a space at the bottom to allow
moisture to escape Fig. 3.
INSTALLATION INSTRUCTION
736 - LED Wall Sconce
WS-W73608
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
FIG.1
Back Plate Dimensions
D1
C1
B1
A1
E1
Mounting Screw
Mounting Screw
Junction Box Screw
Wire Connector
Mounting Plate
Fixture Backplate
Fixture
Ground Wire
Junction Box
Gasket
1 1/8”
Ø4”
1 3/4”
Junction Box
Caulking
Fig.3 Sealing