Installation Instruction

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
Fig.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Position the mounting plate (B1) on the wall, mark the location of the key hole. Pre-drill the holes for plastic anchors (M1) and insert the
plastic anchors (M1) into the wall.
2. Drill holes in the wall aligned with the key-hole location in the mounting plate (B1) insert plastic anchors (M1) into wall holes. Insert wood
screws (J1) into anchors leaving enough length to hang mounting plate (B1).
3. Loose the mounting screw (E1) and put ring to the back plate with screw (G1) and put the glass (D1)in to the xture and screw with the
glass holder (F1) and screw (E1) safety.
4. Insert the wood screws (J1) into the plastic anchors (M1). From the key hole (A1) .Tighten the mounting plate (B1) to the wall.
5. Secure the mounting plate (B1) to the junction, box (N1) using junction box screws (K1). The side of the mounting plate marked
“GND” must face out
CONNECTING THE WIRES (FIG. 2)
6. Making sure that all wire connectors (L1) are secured. If your outlet box has a green or bare copper ground wire, connect the xture’s
ground wire to it. Otherwise. Connect the xture’s ground wire directly to the back plate using the green/ ground screw (C1) provided.
After wires are connected. Tuck them carefully inside the junction box.
7. Put the xture onto the mounting plate(B1) and secure with mounting screws (H1) and gasket (I1).
COMPLETING THE INSTALLATION (FIG. 3)
8. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline
the outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape (Fig.3).
Junction Box
Caulking
Fig.3 Sealing
E1
F1
G1
H1
I1
J1
K1
L1
M1
A1
B1
C1
Screw
Glass
Holder
Glass
Junction
Box
Key Hole
Mounting Plate
Ground
Screw
Junction
Box Screw
Gasket
Mounting
Screw
Screw
Wood
Screw
Plastic
Anchor
Wire
Connector
INSTALLATION INSTRUCTION
Vitrine - Exterior
WS-W32512, WS-W32516
Technology Upgraded
No Driver Required
Driver
(Please direct wire with 120V AC)