Installation Instruction

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Secure the cage (G1) on the back plate (H1) tight with the washer (E1), crew nut (D1) and gasket (F1).
CONNECTING THE WIRES (FIG. 2)
2. Secure the mounting plate (I1) to the junction box using junction box screws (J1). The side of the mounting plate marked
“GND” must be face out.
3. Connect the xture wires with the supply wires as shown in Fig. 2. Make sure that all wire connectors (L1) are secured. If your outlet box has
a ground wire (green or bare copper), connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate (I1) using the green screw provided.
4. Put the xture onto the mounting plate (I1) and secure the mounting screw nut (C1) and gasket (B1) to the mounting screw (A1).
COMPLETING THE INSTALLATION (FIG. 3)
5. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3.
Junction Box
Caulking
Fig.3 Sealing
Technology Upgraded
No Driver Required
Driver
(Please direct wire with 120V AC)
H1
I1
J1
L1
A1
B1
C1
D1
E1
F1
G1
Backplate
Gasket
Washer
Screw Nut
Mounting
Screw nut
Mounting
Plate
Junction
Box
Screw
P3 Wire
Connector
Mounting
Screw
Gasket
Junction
Box
Cage
Fig.1
INSTALLATION INSTRUCTION
Helix - Exterior
WS-W34517, WS-W34524