Installation Instruction

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (FIG. 2)
1. Secure mounting plate (F1) to the junction box (H1) using junction box screws (J1). The side of the mounting plate marked
“GND” must face out.
2. Place the glass (A1) into the xture Using Allen Wrench (B1) with Allen screw( C1). secure the glass( A1) on the xture tight.
3. Connect the xture wires to supply wires as shown in Fig. 2, making sure that all wire connectors (G1) are secured. If your outlet box has
a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
mounting plate (F1) using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
4. Place the xture’s back plate over the mounting plate (F1) and secure with mounting screws (D1) and gaskets (E1).
5. Secure glass into xture using allen screw (C1) by allen wrench (B1).
6. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3.
Junction Box
Caulking
Fig.3 Sealing
Fig.1
G1
F1J1
E1
D1
C1
B1
Wiring Connector
Junction Box
Mounting
Plate
Junction Box
Screw
Gasket
Mounting Screw
Allen Screw
Allen Wrench
Glass
Technology Upgraded
No Driver Required
Driver
(Please direct wire with 120V AC)
INSTALLATION INSTRUCTION
Torch - Exterior
WS-W37520