Assembly Instructions

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
SUSPENSE
WS-W1911, W1915, W1917
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including
the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Secure mounting backplate (DD) to the junction box
(FF) using junction box screws (BB). The side of the
mounting backplate marked “GND” (EE) must face out.
CONNECTING THE WIRES (FIG.2)
4. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors (AA) are secured. If your outlet
box has a ground wire, connect it to the xture’s ground
wire. Otherwise, connect the xture’s ground wire directly
to the backplate (DD) using the green screw (EE) provided.
Tuck wires carefully inside the junction box.
5. Place the xture over the mounting backplate (DD) and
secure with screws (CC). Twist the glass (GG) into the x ture.
COMPLETING INSTALLATION (FIG.3)
6. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of xture back plate
where it meets the wall. Leave a space at bottom to allow
moisture to escape (Fig. 3).
FIG.3
( F1 )
FIG.2
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
F1
A1
C1
E1
D1
B1
G1
C1
Mounting
Backplate
Junction Box
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC LOW
VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON DVELV-300P, SELV-300P, DVCL-153P, CTCL-153PD
LEVITON VPE04, IPE04, IPI06, IPM06, VPI06