Assembly Instructions

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2014
INSTALLATION INSTRUCTION
Urban
WS-W1116, WS-W1122
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for installation
MOUNTING THE FIXTURE (Fig. 1)
3. Secure mounting backplate (D1) to the junction box (F1) using junction box screws (B1).The side of the mounting backplate
marked “GND” (E1) must face out. *Requires Transformer to be recessed within the junction box
CONNECTING THE WIRES (Fig. 3)
4. At this point, connect the electrical wires as shown in Fig. 2, making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire
directly to the backplate (D1) using the green screw (E1) provided. After wires are connected, tuck them carefully inside the
junction box.
5. Place the xture’s backplate over the mounting backplate (D1) and secure with screws (H1), Put the lamp body over the back-
plate and secure with screws (C1) and gasket (G1)
COMPLETING THE INSTALLATION (Fig. 3)
6. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant)
to outline the outside of xture backplate where it meets the wall. Leave a space at bottom to allow moisture a means to escape.
G1
C1
H1
J1
F1
K1
C1
H1
J1
J1
FIG.1
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
(F1)
FIG.3