Assembly Instructions

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
Vetri
WS-3919, WS-3925, WS-3937
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary
for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove screws (C1) from the xture. Remove connectors (K1).
4. Connect the transformer input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are
secured. If your outlet box has a ground wire (L1) (green or bare copper), connect the xture’s ground wire to it. Otherwise,
connect the xture’s ground wire directly to the back plate (I1) using the green screw (H1) provided. After wires are connected,
tuck them carefully inside the junction box. *Requires Transformer to be recessed within the junction box
MOUNTING THE FIXTURE (Fig. 1)
5. Secure mounting backplate (I1) to the junction Box (F1) using junction box screws (B1).
The side of the mounting backplate marked “GND” (H1) must face out.
6. Connect the xture’s wires (Blue & Red) to the Transformer’s (J1)
output wires (Red and Red) – Blue to Red and Red to the other Red.
7. Place the xture’s canopy plate (M1) over the mounting back plate (I1)
and secure with screws (C1).
8. Install the glass (G1) on the front of xture with
screws (D1) and plastic washer (E1).
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
C1
I1
M1
D1 E1
G1
K1
A1
F1
L1
J1
FIG.1