Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
MAGIC
WS-12620
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
3. Remove the mounting screws (C1) from the xture.
4. Connect the xture wires to supplier wires as shown in
Fig. 2, making sure that all wire connectors (A1) secured.
Fixture and junction box ground wires should be connected
to mounting plate using green screw provided. After wires
are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure the mounting plate (D1) to the junction box (F1)
using the junction box screws (B1).The side of the mounting
plate marked “GND” must face out.
6. Place the xture back plate (G1) over the mounting
plate (D1) and secure with the mounting screws (C1).
7. Thread the glass (H1) onto the xture.
H1
A1
F1B1
D1G1
C1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Glass
Fixture
Screw
Back
Plate
Mounting
Plate
Mounting
Screw
Junction
Box
Wire
Connector