Assembly Instructions

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
MAGIC
WS-12622
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from
the xture.
4. Secure the mounting plate (D1) to the
junction box (F1) using the junction box
screws (B1).The side of the mounting plate
marked “GND” (E1) must face out.
*Requires driver to be recessed within
the junction box
CONNECTING THE WIRES (Fig. 2)
5. Connect the transformer input wires to supply wires as
shown in Fig. 2. Connect the driver output wires to the
xture wires. red (+) to red (+), black (-) to black (-).
Making sure that all wire connectors secured.
If your outlet box has a green or bare copper ground
wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly
to the mounting plate (D1) using the green screw provided.
After wires are connected, tuck them carefully inside the
junction box.
6. Place the xture back plate (G1) over the
mounting plate (D1) and secure with the
mounting screws (C1).
7. Thread the glass (H1) onto the xture.
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
H1
A1
F1B1
D1
G1
C1
FIG.1