Assembly Instructions

Modernforms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAY, 2014
INSTALLATION INSTRUCTION
BLADE
WS-11511, 11522
PREPARATION
1. Shut o the power at the circuit breaker
and remove existing xture, including
the mounting hardware.
2. Carefully unpack your new xture
and lay out all the parts on a clear area.
Be careful not to lose any small parts
necessary for installation.
3. Remove the mounting screws (C1) from the xture.
MOUNTING THE FIXTURE (Fig. 1)
For Switch Box
4. Secure mounting plate (E1) to the switch box (F1)
using screws (B1). The side of the mounting plate
marked “GND” (E1) must face out.
For Junction Box (if necessary)
5. Secure the mounting ring (D1) to the junction box (F1)
using junction box screws (B1). Make sure the two holes
(spacing 2-3/4”) is vertical direction as shown in Fig, 2.
6. Put the mounting plate (E1) and the conversation plate
(G1) onto the mounting ring (D1). Make sure the two holes
on mounting plate (E1), the two slots on conversation plate
(G1) and the two holes (spacing 2-3/4”) is aligned. Fasten
them using screws (I1).
CONNECTING THE WIRES (Fig. 2)
7.Connect the electrical wires as shown in Fig, 3, making
sure that all wire connectors are secured. If your outlet
box has a green or bare copper ground wire, connect the
xture’s ground wire to it. Otherwise, connect the xture’s
ground wire directly to the mounting plate (E1)
using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
8. Place the xture back plate (H1) over the mounting plate
(E1) and secure with screws (C1).
FIG.3
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
For Junction Box (if necessary)
For Switch box
H1
B1
C1
E1
A1
F1
I1
C1
E1
A1
G1
B1
D1
F1
FIG.1