Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
TWILIGHT
WS-W5516, W5521
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Secure the mounting plate (D1) to the junction box (F1)
using junction box screws (B1). The side of the mounting
plate marked “GND” must face out.
CONNECTING THE WIRES (FIG.2)
4. Connect the electrical wires as shown in Fig. 2, making
sure that all wire connectors (A1) are secured. Fixture and
junction box ground wires should be connected to
mounting plate using green screw provided.
Tuck wires carefully inside the junction box.
5. Place the xture’s back plate over the mounting plate (D1)
and secure with screws (G1) and gasket (C1).
6. If desired, the decorative insert may be removed by
unscrewing the nut (H1) from the back of the xture
COMPLETING INSTALLATION (FIG.3)
7. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of xture back plate
where it meets the wall. Leave a space at the bottom to
allow moisture to escape (Fig.3).
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
F1
H1
A1
C1
G1
D1
B1
G1
C1
Junction Box
Wire
Connector
Gasket
Screw
Mounting Plate
Junction Box Screw
Fixture Screw
Gasket
Nut
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Junction Box
Caulking
Fig.3 Sealing