Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including
the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG.1)
3. Twist the glass (H1) into the lamp.
4. Secure the mounting plate (D1) to the junction box
(F1) using junction box screws (B1).
The side of the mounting plate marked
“GND” must face out.
CONNECTING THE WIRES (FIG.2)
5. Connect the electrical wires as shown in Fig. 2,
making sure that all wire connectors (A1) are secured.
If your outlet box has a ground wire, connect it to the
xture’s ground wire. Otherwise, connect the xture’s
ground wire directly to the mounting plate (D1) using the
green screw (E1) provided. Tuck wires carefully inside the
junction box.
6. This xture may be dimmed with an electronic
low voltage dimmer switch or with a 0-10V dimmer switch.
If needed, connect the brown (BR or +) / blue (BL or -) wires
of the driver with the 0-10V dimmer switch (not provided).
7. Place the xture’s back plate over the mounting plate (D1)
and secure with screws (G1) and gasket (C1).
8. Twisted lock the glass (H1) into xture well.
COMPLETING INSTALLATION (FIG.3)
9. To prevent moisture from entering the outlet box and
causing a short, use clear caulking (i.e. indoor/outdoor
silicone sealant) to outline the outside of xture back plate
where it meets the wall. Leave a space at the bottom to
allow moisture to escape (Fig.3).
INSTALLATION INSTRUCTION
STRUCTURE
WS-W5411, W5416
FIG.1
B1
E1
F1
A1
G1C1
D1
B1
H1
Junction
Box
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Junction Box
Caulking
Fig.3 Sealing