Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2015
INSTALLATION INSTRUCTION
MAGIC
WS-12622
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts necessary
for installation.
3. Remove the mounting screws (C1) from the xture.
4. Connect the transformer input wires to supply wires as shown
in Fig. 2. Connect the driver output wires to the xture wires.
red (+) to red (+), black (-) to black (-). Making sure that all wire
connectors secured. If your outlet box has a green or bare
copper ground wire, connect the xture’s ground wire
to it. Otherwise, connect the xture’s ground wire directly to
the mounting plate (DD) using the green screw provided.
After wires are connected, tuck them carefully inside the
junction box.
5. Secure the mounting plate (D1) to the junction box (F1) using
the junction box screws (B1).The side of the mounting plate
marked “GND” must face out.
*Requires driver to be recessed within junction box
6. Place the xture back plate (G1) over the mounting plate (D1)
and secure with the mounting screws (C1).
7. Thread the glass (H1) onto the xture.
H1
A1
F1B1
D1G1
C1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Mounting
Plate
Junction
Box
Driver
Output
Input
Mounting
Screw
Mounting
Plate
Back
Plate
Fixture
Screw
Back Plate Dimensions
4 1/4”
1 3/4”
4 1/8”
1 3/8”