Assembly Instructions

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
MAGIC
WS-12620
PREPARATION
1. Shut o the power at the circuit breaker and
remove existing xture, including the mounting hardware.
2. Carefully unpack your new xture and lay out
all the parts on a clear area. Be careful not to lose
any small parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) fromthe xture.
4. Secure the mounting plate (D1) to the junction box (F1)
using the junction box screws (B1).The side of the mounting
plate marked “GND” (E1) must face out.
*Requires driver to be recessed within the junction box
CONNECTING THE WIRES (Fig. 2)
5. Connect the transformer input wires to
supply wires as shown in Fig. 2. Connect the driver
output wires to the xture wires.
red (+) to red (+), black (-) to black (-), making sure
that all wire connectors secured. If your outlet box
has a green or bare copper ground wire, connect
the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the mounting plate (D1)
using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
6. Place the xture back plate (G1) over the
mounting plate (D1) and secure with the
mounting screws (C1).
7. Thread the glass (H1) onto the xture.
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
H1
A1
F1B1
D1G1
C1
FIG.1