Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. 2
PREPARATION
1. Carefully unpack your new lamp, lay out all the parts on a
clear area. Be careful not to lose any small parts.
2. Secure the base to the lamp body with Allen screw (A) with
Allen wrench (B).
3. Remove the Allen screw ($) from lamp head using Allen
wrench (%), take down the end cap.
4. Slide the lamp head into the pulley, secure the end cap to
the lamp head using Allen screw ($) with Allen wrench (%).
5. Connect connector cable to the power supply.
6. Plug into outlet.
7. Slide up and down the lamp head to the perfect height;
8. Slide horizontally the lamp head to your desired location.
9. This lamp features a touch dimmer.
• To choose desired brightness:
• 1st tap – Turn on
• 2nd tap – Brighter
• 3rd tap – Max. Brightness
FIG.1
INSTALLATION INSTRUCTION
1950-Floor Lamp
FL-1950
G0
A
B
A
B
Allen Screw
Allen Wrench
Base
Connector
Power Supply
Lamp Body
Pulley
Lamp Head
Switch
C
D
Allen Wrench
Allen Screw
End Cap