Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
GLACIER
WS-6519, 6528, 6537
PREPARATION
1. Shut o the power at the circuit breaker
and remove existing xture, including the
mounting hardware.
2. Carefully unpack your new xture and
lay out all the parts on a clear area.
Be careful not to lose any small parts
necessary for installation.
3. Remove mounting screws (C1) from xture.
4. Drill holes in the wall aligned with the key-hole location in the mounting plate (D1). Insert the mounting anchors (K1).
5. Connect the xture wires to junction box as shown in Fig. 2, making sure that all wire connectors (A1) secured. Fixture and
junction box ground wires should be connected to mounting plate using green screw provided. After wires are connected,
tuck them carefully inside the junction box.
6. Secure the mounting plate (D1) to the junction box (F1) using the junction box screws (B1). The side of the mounting plate
marked “GND” must face out.
7. Fasten the wood screws (J1) into the mounting anchors (K1). Tighten the mounting plate (D1) onto the wall.
8. Place the xture back plate (G1) over the mounting plate (D1) and secure with mounting screws (C1).
9. Insert the glass (E1) into the holder. Secure with Allen screws (I1) and Allen wrench (H1) provided.
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
J1
C1
G1
I1H1
E1
K1
D1
B1
A1
F1
FIG.1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring
Glass
Junction
Box
Wire
Connector
Mounting
Plate
Anchor
Mounting
Screw
Fixture
Screw
Fixture
Backplate
Allen
Screw
Allen
Wrench
Junction
Box Screw