Installation & Assembly

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modernforms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
GLACIER
WS-6509
FIG.2
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare Copper
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
100%-10% DIMMING
COMPATIBLE WITH THE FOLLOWING ELECTRONIC
LOW VOLTAGE (ELV) DIMMERS
Brand Model
LUTRON SELV-300P
LUTRON DVELV-300P
LEVITON MLE03-1
PREPARATION
1. Shut o the power at the circuit breaker
and remove existing xture, including
the mounting hardware.
2. Carefully unpack your new xture and
lay out all the parts on a clear area.
Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Secure the mounting plate (D1)
to the junction box (F1) using the
junction box screws (B1). The side of
the mounting plate marked “GND” (D1)
must face out.
CONNECTING THE WIRES (Fig. 2)
4. Connect the xture wires to supplier
wires as shown in Fig. 2, making sure
that all wire connectors (A1) secured.
If your outlet box has a green or bare
copper ground wire, connect the xture’s
ground wire to it. Otherwise, connect the
xture’s ground wire directly to the mounting
plate (D1) using the green screw provided.
After wires are connected, tuck them carefully
inside the junction box.
5. Place the xture back plate (G1) over the
mounting plate (D1) and secure with
mounting screws (C1).
6. Put the glass (E1) onto the holder. Secure with
Allen screws (I1) and Allen wrench (H1) provided.
A1
F1
D1
B1
I1
H1
G1
C1
E1
FIG.1