Installation Sheet

FR-W2201-65L
Wyndmill Instructions12
2. Installing the Hanger Bracket
Remember to disconnect the power at the circuit breaker.
1. Remove 1 of 2 screws from the bottom of the mounting bracketand
save for use in section 11. Loosen the other screw (Fig. 2).
2. Pass the 120-volt supply wires through the center hole in
themounting bracket as shown (Fig. 2A).
3. Secure the mounting bracket to the ceiling outlet box with
thescrews and washers provided with your outlet box. Use Part A
if needed to mount your Outlet Box.
4. Before you install the blades/blade arms - remove and discardthe
rubber motor stops from the motor housing.
NOTE: Make sure that mounting screws are tight.
1. Attach the blade to blade arm using the screws and washers the
blade press plates on top of the blade and placing the blade on
the blade arm as shown. (Fig. 3/4)
Use Part B.
2. Fasten blade assembly to the outer ring of the motor housing
using the supplied screws (Fig.5). Use Part C
3. Attaching the Fan Blades/Arms