Installation Guide

FR-W2001
Renegade Instructions12
3. Attaching the Fan Blade/Arms
2. Installing the Mounting Bracket
Remember to disconnect the power at the circuit breaker.
1. Remove 1 of 2 screws from the bottom of the mounting bracket
and save for use in section 11. Loosen the other screw (Fig. 2).
2. Pass the 120-volt supply wires through the center hole in the
mounting bracket as shown (Fig. 2A).
3. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box.
NOTE: Make sure that mounting screws are tight.
1. Attach the blade to blade arm using the screws from washers as
shown in (Fig. 3).
2. Fasten blade assembly to motor using screws supplied (Fig.3).