Installation Guide

15FR-W1817
Canopy screw cover
FIGURE 16
Canopy
Screws
Mounting
Bracket
Outlet
Box
9. FINISHING THE INSTALLATION
1. Secure all wire connections with supplied wire ties to assist in
canopy installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to mounting bracket and place the key hole
on the canopy over the screw on the mounting bracket. Turn can-
opy until it locks in place at the narrow section of the key holes.
(Fig. 16)
4. Align the circular hole on canopy with the remaining hole on the
mounting bracket. Secure by tightening the one screw previously
loosened and the one screw previously removed.
5. Adjust the canopy screws as necessary until the canopy and cano-
py cover are snug.
WARNING: Make sure tab at bottom of mounting bracket is
properly seated in groove of hanger ball before attaching canopy
to bracket. Failure to properly seat tab in groove could cause
damage to electrical wiring.