Troubleshooting Guide

16FR-W1817
FIGURE 17
FIGURE 18
Screws with
Rubber Washers
Blade Support
Plate
Blade
Blade Arm
Screws
Mounting Ring
Adapter Plate
Screws
10. ATTACHING THE FAN BLADES
1. Attach the blade to the blade arm using the screws with rubber
washers as shown in Fig. 17.
2. Fasten blade assembly to motor using the screws supplied.
(Fig. 17)
11. INSTALLING THE ADAPTER PLATE
1. Remove one of the three screws from the mounting ring and
loosen the other two screws. (Do not remove.)
2. Place the key holes in the adapter plate over the two screws pre-
viously loosened from the mounting ring. Turn the adapter plate
until the adapter plate locks in place at the narrow section of the
key holes. (Fig. 18)
3. Tighten the two mounting ring screws previously loosened and
the one previously removed to secure adapter plate.