Installation Guide

FR-W1817Osprey Instructions22
8. Installing the LED Luminaire Module
WARNING: Before starting installation, disconnect the power
by turning o the circuit breaker or removing the fuse at fuse box.
1. Remove 3 screws from the outer perimeter of the adapter plate.
2. Raise and hold the LED luminaire module close to the adapter
plate and proceed to secure the wire connections. Connect the
white wire connectors from the luminaire module to the white
wire of the fan. Connect the blue wire from the fan to the black
wire from the LED module. (Fig. 8).
3. Tuck connections neatly into adapter plate. Place the luminaire
module key holes over the 2 screws previously loosened from
the adapter plate. Turn luminaire module until it locks in place
at the narrow section of the key holes. Secure by tightening the
2 screws previously loosened and the one previously removed
(Fig. 8).
4. Raise fresnal glass shade up against the luminaire module,
and secure it to fan by turning acrylic shade clockwise until
snug. Do not overtighten.