Installation Guide

19FR-W1812; FR-W1813

13. INSTALLING THE LED LUMINAIRE MODULE (OPTIONAL)

WARNING: Before starting installation, disconnect the power by turn-

ing o the circuit breaker or removing the fuse at fuse box.

NOTE: If you do not plan to install the luminaire module with your fan

at this time, skip to Step 4.

FIGURE 23

FIGURE 22

FIGURE 21

1. Remove 1 of the 3 screws from the outer perimeter of the adapter

plate and keep it for future use. Loosen the other 2 screws (Do not

remove).

2. Raise and hold the LED luminaire module close to the adapter plate

and proceed to secure the wire connections. Connect the white wire

connector from the luminaire module to the white wire of the fan.

Follow the same procedure with the black wire connectors (Fig. 21).

3. Tuck connections neatly into adapter plate. Place the luminaire

module key holes over the 2 screws previously loosened from the

adapter plate. Turn luminaire module until it locks in place at the

narrow section of the key holes. Secure by tightening the 2 screws

previously loosened and the one previously removed (Fig. 23).

4. Raise glass shade up against the luminaire module, and secure it to

fan by turning glass shade clockwise until snug. Do not overtighten.