Installation Guide

FR-W1813Morpheus Instructions12

Remember to turn o power at the breaker.

Follow the steps below to hang your fan properly:

1. Disconnect power at the breaker to the fan location. A licensed

electrician must install the fan.

2. Remove 1 of 2 screws from the bottom of mounting bracket and

save for use in Finishing the Installation section. Loosen the other

screw (Fig. 2).

3. Pass the 120-volt supply wires through the center hole in the

ceiling mounting bracket as shown in (Fig. 2A).

4. Secure the mounting bracket to the ceiling outlet box with the

screws and washers provided with your outlet box (Fig. 2A).

2. Hanging the Fan

3. Attaching the Fan Blades

1. Remove and discard the 2 pre-installed screws on the motor

as shown (Fig. 3A).

2. Attach the fan blades with the blade screws provided (Fig. 3).

3. Turn the fan motor assembly over and install the blade collector

ring with the screws provided (Fig. 3B).