Installation Guide

9FR-W1806
6. HANGING THE FAN (cont.)
FIGURE 8
FIGURE 9
Cross Pin
Hanger
Ball
Downrod
Downrod
Clevis Pin
Cotter Pin
Screws (2)
Collar
Safety Cable
Motor Wires
Screw
1. Take out the screw located in the hanger ball, lower the hanger ball and
remove the cross pin. Remove the hanger ball from the hanger ball/
downrod assembly (Fig. 8).
2. Remove the clevis pin and cotter pin, and loosen the two collar screws
from the motor collar (Fig. 9).
3. Carefully feed the motor wires and safety cable up through the downrod.
Thread the downrod into the collar.
4. Align the holes of downrod and collar and insert the cotter pin and clevis
pin. Tighten the two collar screws (Fig. 9).
WARNING: Failure to properly install the cotter pin and/or tighten the screws
could result in the fan loosening and possibly falling.