Installation Guide

8FR-W1806
6. HANGING THE FAN
REMEMBER to turn o power at the breaker.
Follow the steps below to hang your fan properly:
1. Disconnect power at the breaker to the fan location. A licensed electri-
cian must install the fan (Fig. 5).
2. Remove 1 of 2 screws from the bottom of mounting bracket and save for
use in section 9. Loosen the other screw (Fig. 6).
3. Pass the 120-volt supply wires through the center hole in the ceiling
mounting bracket as shown in (Fig. 7).
4. Secure the mounting bracket to the ceiling outlet box with the screws
and washers provided with your outlet box (Fig. 7).
FIGURE 5
FIGURE 6
FIGURE 7
Mounting Bracket
Screw
UL/cUL Listed
Electrical Box
Mounting
Bracket
Mounting Screws
(supplied with
outlet box)
120V Wire