Installation Guide

17FR-W1806
12. INSTALLING THE LED LUMINAIRE MODULE
WARNING: Before starting installation, disconnect the power by turning o the
circuit breaker or removing the fuse at fuse box.
NOTE: If you do not plan to install the luminaire module with your fan at this time,
skip to step 5.
FIGURE 19
LED Luminaire Module
1. Remove 1 of the 3 screws from the outer perimeter of the adapter plate and keep it
for future use. Loosen the other 2 screws (Do not remove).
2. Raise and hold the LED luminaire module close to the adapter plate and proceed to
secure the wire connections. Connect the white wire connectors from the luminaire
module to the white wire of the fan. Follow the same procedure with the black wire
connectors (Fig. 19).
3. Tuck connections neatly into adapter plate. Place the luminaire module key holes
over the 2 screws previously loosened from the adapter plate. Turn luminaire module
until it locks in place at the narrow section of the key holes. Secure by tightening the
2 screws previously loosened and the one previously removed (Fig. 19).
4. Raise acrylic shade up against the luminaire module, and secure it to fan by turning
acrylic shade clockwise until snug. Do not overtighten.
Connection Plugs
Screws
Glass Shade
Adapter Plate