Installation Guide

15FR-W1806
9. FINISHING THE INSTALLATION
Canopy Screw Cover
FIGURE 16
Canopy
Screws
Hanger
Bracket
Outlet
Box
1. Secure all wire connections with supplied wire ties to assist in canopy
installation.
2. Tuck connections neatly into ceiling outlet box.
3. Slide the canopy up to hanger bracket and place the key hole on the
canopy over the screw on the hanger bracket. Turn canopy until it locks in
place at the narrow section of the key holes (Fig. 16).
4. Align the circular hole on canopy with the remaining hole on the hanger
bracket. Secure by tightening the one screw previously loosened and the
one previously removed.
5. Adjust the canopy screws as necessary until the canopy and
canopy cover are snug.
WARNING: Make sure tab at bottom of hanger bracket is properly seated in
groove of hanger ball before attaching canopy to bracket. Failure to properly
seat tab in groove could cause damage to electrical wiring.