Installation Guide

10FR-W1806

6. HANGING THE FAN (cont.)

Motor Wires

Canopy

Downrod

Coupling Cover

Canopy Screw Cover

Safety Cable

FIGURE 11

FIGURE 10

1. Slip the coupling cover, canopy screw cover (painted side face down), and

canopy (opened side up) onto the downrod (Fig. 10). Coupling cover goes

all the way to the bottom.

2. Carefully reinstall the hanger ball onto the downrod, being sure that the

cross pin is in the correct position, the setscrew is

tightened and wires are not twisted (Fig. 10).

3. Carefully lift the fan motor assembly up to the mounting bracket and seat

the hanger ball in the mounting bracket socket.

Make sure the tab on the mounting bracket socket is properly seated in

the groove in the hanger ball (Fig. 11). Rotate the socket assembly until

the ball drops and locks into the hanger bracket screw.

4. Secure the safety cable to the building structure using a wood screw (not

included) (Fig. 11).

Wood Screw