Installation Sheet
18FR-W1805
12. INSTALLING THE LED LUMINAIRE MODULE
WARNING: Before starting installation, disconnect the power by turning
o the circuit breaker or removing the fuse at fuse box. Turning power o
using the fan switch is not sucient to prevent electric shock.
NOTE: If you do not plan to install the luminaire module with
your fan at this time, skip to step 5.
1. Remove 1 of the 3 screws from the outer perimeter of the
adapter plate and keep it for future use. Loosen the other 2
screws (Do not remove)
2. Raise and hold the LED luminaire module close to the adapter
plate and proceed to secure the wire connections. Connect the
white wire connector from the luminaire module to the white
wire of the fan. Follow the same procedure with the black wire
connectors. (Fig. 20)
3. Tuck connections neatly into adapter plate. Place the luminaire
module key holes over the 2 screws previously loosened from the
mounting ring, turn luminaire module until it locks in place at the
narrow section of the key holes. Secure by tightening the 2 screws
previously loosened and the one previously removed. (Fig. 20)
4. Raise glass shade up against the luminaire module, and secure it
to fan by turning glass clockwise until snug. Do not over-tighten.
FIGURE 20
Adapter
plate
ScrewsLED Luminaire module
Connection plugs
Glass
shade