Installation Guide

10FR-W1803

6. HANGING THE FAN (cont.)

Canopy screw

cover

Canopy

Safety Cable

Wood Screw

Motor Wires

Downrod

Coupling Cover

FIGURE 10

FIGURE 11

1. Slip the coupling cover, canopy screw cover (painted side face

down), and canopy (opened side up) onto the downrod. (Fig. 10).

Coupling cover goes all the way to the bottom.

2. Carefully reinstall the hanger ball onto the downrod, being sure

that the cross pin is in the correct position, the setscrew is

tightened and wires are not twisted. (Fig. 10)

3. Carefully lift the fan motor assembly up to the mounting bracket

and seat the hanger ball in the mounting bracket socket.

Make sure the tab on the mounting bracket socket is properly

seated in the groove in the hanger ball. (Fig. 11) Rotate the socket

assembly until the ball drops and locks into the hanger bracket

screw.

4. Secure the safety cable to the building structure using a wood

screw (not included). (Fig. 11)