Installation Guide

9FR-W1803

6. HANGING THE FAN (cont.)

FIGURE 8

FIGURE 9

Cross pin

Hanger

ball

Downrod

Clevis pin

Cotter pin

Screws (2)

Collar

Safety cable

Motor wires

Set screw

1. Take out the set screw located in the hanger ball, lower the

hanger ball and remove the cross pin. Remove the hanger ball

from the hanger ball/downrod assembly. (Fig. 8)

2. Remove the clevis pin and cotter pin, and loosen the two collar

screws from the motor collar. (Fig. 9)

3. Carefully feed the motor wires and safety cable up through the

downrod. Thread the downrod into the collar.

4. Align the holes of downrod and collar and insert the cotter pin

and clevis pin. Tighten the two collar screws. (Fig. 9)

WARNING: Failure to properly install the cotter pin and/or tighten the

screws could result in the fan loosening and possibly falling.