Installation Sheet
Table Of Contents
2
INSTALLATION INSTRUCTIONS
FM-W76108
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Junction Box
Caulking
3000K3500K
2700K
Junction Box
Mounting Plate
Allen Wrench
Allen Screw
Canopy
Junction Box Screw
Input Wires
Wire Connector
Acrylic Lampshade
(Include Inside Lampshade)
3CCT Switch
A
B
C
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not lose any small parts necessary for installation.
3. Remove the mounting plate from the xture，and Secure mounting plate to the junction box using junction box screw.
Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
4. Connect the xture wires with supply wires as shown in Fig. 2, making sure all wire connector (A) are secured. If your outlet box has a green or
bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the mounting plate
using the screw provided. After all wires are connected, tuck them carefully inside the junction box.
5. The lamp can switch between three color temperatures (2700k-3000k-3500k), which can be adjusted to your preference with the switch in the
canopy .(Fig.4)
6. Secure the xture by mounting the canopy to the ring of the back plate. Turn and rotate the canopy in the direction of the arrow until it stops.
then lock it with Allen screw (B) using Allen wench (C).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture canopy where it meets the wall . (Fig 3)
Note: The screw hole of the lamp body also needs to be lled.
″
″
″