Installation Sheet


dweLED.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
2
INSTALLATION INSTRUCTION
FM-WXX205
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)



1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

3. The lamp can switch between three color temperatures (3000K-3500K-4000K),which can be adjusted to your preference with
the switch in the canopy (Fig. 3).
4. Connect the driver’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet
box has a green or bare copper ground wire, connect the driver’s ground wire to it. Otherwise, connect the xture’s ground wire directly
to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.

5. Secure the mounting back plate on canopy to the junction box using standard junction box screws that comes with the junction box.
(i)using any other non-original-manufacturer provided junction box screw may result in safty issue.
6. Connect the xture to the driver output wires securely with the DC terminal.

7. Tuck the wires and DC terminal carefully inside the canopy (Fig.4), snap the xture upwards on the canopy and make sure
the xture assembly is ush and secure.
8. Press on the front of the rotatable lens and adjust to your desired beam direction.
3000 k
3500k
4000k
3000K 3500K 4000K
DC terminal

1 3/8"1 3/4"
Ø4 7/8"


Fixture
Canopy
Driver
Wire Connector
A
Junction box
Mounting back plate
Junction Box Screw
DC terminal
Switch
Rotatable lens