Installation Sheet
2
INSTALLATION INSTRUCTIONS
FM-78118
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
Mounting Ring Dimensions
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not lose any small parts necessary for installation.
3. Remove the mounting ring from the xture,and Secure mounting ring to the junction box using junction box screw.
Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
4. Connect the xture wires with supply wires as shown in Fig. 2, making sure all wire connector (A) are secured. If your outlet box has a green or
bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the mounting plate
using the screw provided. After all wires are connected, tuck them carefully inside the junction box.
5. Place the xture on the mounting ring and secure it with mounting screw (D).
6. Insert the glass into the xture and rotate to lock in place
,
secure
it with Allen screw (B) using Allen wench (C).
GN
D
1 3/4"
1 3/8"
Ø4
"
A
B
C
Junction Box
Wire Connector
White wire
Black wire
Junction Box Screw
Mounting Ring
Ground wire
Glass
(RPL-GLA-78118)
Fixture
Allen Wrench
Allen Strew
Mounting Screw
D