Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. DECEMBER, 2014 2
INSTALLATION INSTRUCTION
Razor - Flush Mount
FM-4716
Fig. 1
Technology Upgraded
No Driver Required
Driver
(Please direct wire with 120V AC)
PREPARATION
- Shut o the power at the circuit breaker and remove existing xture, including the mounting hardware.
- Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
1. Drill holes in the ceiling aligned with the key-hole location in the mounting plate (E1). Insert the plastic anchors (G1).
2. Secure the mounting plate (E1) to the junction box using the junction box screws (J1).
3. The side of the mounting plate marked “GND” must face out.
4. Screw the wood screws (P1) into the plastic anchors (G1). Tighten the mounting plate (E1).
5. Place the glass into the xture (M1). Secure the plate (D1) onto the xture (M1) using screws (C1).
Hold the glass on right location well.
6. Hang the hook of safety cable (H1) onto the mounting plate (E1). This will allow for xture to be supported while wire connection are made.
CONNECTING THE WIRES (FIG. 2)
7. Connect the xture wires to supply wires as shown in Fig.2, making sure
that all wire connectors (B1) are secured. If your outlet box has a green
or bare copper ground wire, connect the xture’s ground wire to it.
Otherwise, connect the xture’s ground wire directly to the mounting
plate (E1) using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
8. Put the xture (M1) onto the mounting plate (E1) and
secure them using the mounting screws (A1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
D1
C1
P1
J1
H1
B1
E1
G1
A1
M1
Mounting Plate
Screw
Glass
Mounting Screw
Wood Screw
Junction Box Screw
Safety Cable
Wire Connector
Mounting Plate
Anchor
Junction Box
Fixture