Installation Sheet
Table Of Contents
2
INSTALLATION INSTRUCTIONS
FM-41706
Phone (800) 526.2588
Fax (800) 526.2585
44 Harbor Park Drive
Port Washington, NY 11050
1600 Distribution Ct
Lithia Springs, GA 30122
1750 Archibald Avenue
Ontario, CA 91760
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not lose any small parts necessary for installation.
3. Remove the mounting plate from the xture,and Secure mounting plate to the junction box using junction box screw.
Note: (i) using any other non-original-manufacturer provided junction box screw may result in safety issue;
(ii) The side of the mounting plate marked “GND” must face out.
4. Connect the xture’s wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet box
has a green or bare copper ground wire, connect the xture’s ground wire to it. Otherwise, connect the xture’s ground wire directly to the
back plate using the screw provided. After wires are connected, tuck them carefully inside the junction box.
5. Secure the lamp body to the ring of the mounting plate. Turn and rotate the lamp body in the direction of the arrow until it stops.
then lock it with mounting screw (B) .
Mounting Screw
Junction Box
Mounting
Backplate
Wire
Connector
Lamp Body
K9 Crystal
RPL-GLA-41706
Junction Box Screw
A
B