Installation Guide

Modern Forms
www.modernforms.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program. SEPTEMBER, 2014
INSTALLATION INSTRUCTION
Loft
FM-3610, FM-3615
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small
parts necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Connect the transformer input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A1) are
secured. If your outlet box has a green or bare copper ground wire (I1), connect the xture’s ground wire to it. Otherwise, connect
the xture’s ground wire directly to the back plate (D1) using the green screw (E1) provided. After wires are connected, tuck them
carefully inside the junction box.
*Requires Transformer to be recessed within the junction box
CONNECTING THE WIRES (Fig. 2)
4. Secure mounting backplate (D1) to the junction box (F1) using junction box screws (B1).
The side of the mounting backplate marked “GND” (E1) must face out.
*Requires Transformer to be recessed within the junction box
5. Connect the xture’s blue and red wires to the transformer’s
red output wires; blue to red; red to the other red.
Use wire connectors (K1).
6. Place the canopy plate (L1) over the mounting back plate (D1)
and secure with screws (H1).
7. Twist-lock the glass (G1) into the canopy plate (L1).
J1
D1
B1
K1
H1
G1
L1
C1
I1
A1
F1
FIG.1
Junction Box
Ground Wire
Blue Fixture Wire
Canopy Plate
Transformer
Mounting
Backplate
Connectors
Transformer output wires-red
Red xture wire
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig.2 Wiring