Installation Sheet

2
INSTALLATION INSTRUCTION

FM-24818
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)



1. Shut o the power at the circuit breaker and remove existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.

3. Remove the mounting back plate from the xture.
4. Secure the mounting back plate to the junction box using standard junction box screws that comes with the junction box.
 (i)using any other non-original-manufacturer provided junction box screw may result in safety issue.
(ii) The side of the mounting ring marked “GND” must face out.

5. Connect the driver’s input wires to junction box wires as shown (Fig. 2). Make sure that all wire connectors (A) are secure. If your outlet
box has a green or bare copper ground wire, connect the driver’s ground wire to it. Otherwise, connect the xture’s ground wire
directly to the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.

6. Secure the xture by mounting the canopy to the ring of the backplate. Turn and rotate the canopy in the direction of the arrow until
it stops. Fasten the canopy to the mounting backplate using the mounting screw (D).
Jun. 2021Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
Modern Forms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Junction box
Mounting back plate
Canopy
Junction Box Screw
Wood screw
Plastic anchor
Driver
Fixture
Wire Connector
A
Mounting Screw
D
B
C
Ø16 3/8"
Ø14 5/8"
2 3/4"
3 1/2"
Mounting Back Plate