Installation Sheet

FH-W2202-5 4L
Skylark Flush Instructions20
8. Finishing Hanging the Fan
9. Installing Adapter Plate
1. Secure wire connectors with supplied wire ties.
2. Twist to loosen the trim ring from the motor housing. Remove 1
and loosen 2 mounting screws from the top of the fan’s housing.
Put 1 mounting screw aside. Remove the motor from the hook on
the mounting bracket. Slide the motor up to the mounting
bracket and twist lock the housing into place by aligning the
screws into the grooves of the mounting plate. Locate the 1
mounting screw you put aside and screw it into the 1 remaining
hole in the mounting bracket.
3.
4.
Tighten all 3 screws and twist the decorative trim ring into place
(Fig. 8A).
Make sure you align the grooves of the trim ring as show.
(Fig. 8B)
1. Remove 1 of 3 screws and loosen the others (do not remove).
2. Twist lock adapter plate into place.
3. Using the screw from the previous step, install the
adapter plate (Fig. 9).