Installation Guide

FH-W2004
TipTop Instructions20
8. Finishing the Installation
9. Installing Adapter Plate
1. Secure wire connectors with supplied wire ties (Fig. 8).
2. Install motor housing to mounting plate with the screw
removed as in Step 2. Remove the motor from the hook on
the mounting bracket. Slide the motor up to the mounting
bracket and place the key hole on the motor over the screw
on the mounting bracket. Turn motor until it locks in place at
the narrow section of the key holes. Align the circular hole on
canopy with the remaining hole on the mounting bracket. Secure
by tightening the two screws previously loosened and the two
screws previously removed.
3. Install the trim ring as shown (Fig. 8A).
1. Remove 1 of 3 screws and loosen the others (do not remove).
2. Using the screw from the previous step, install the
adapter plate (Fig. 9).