Installation Guide

FH-W2004
TipTop Instructions12
2. Installing the Mounting Bracket
Remember to disconnect the power at the circuit breaker.
1. Remove 1 set screw from mounting bracket and set
aside for use in Finishing the Installation.
2. Pass supply wires through mounting bracket and
secure to outlet box.
1. Place blade on motor and secure with the blade attachment,
screws and washers.
2. Insert blades in slots, aligning with motor assembly holes.
3. Secure blades with blade attachment screws & washers.
4. Remove set screws from motor housing, install blade collector
ring (when applicable), and re-install screws.
3. Attaching the Fan Blade
1. Remove three screws from the top of the motor housing and place
the decorative trim ring on the body of fan housing as shown.
2. Reattach the motor housing by re-installing the three screws.
4. Adding the Decorative Trim Ring