Installation Sheet

9FH-W1811
6. INSTALLING THE MOUNTING BRACKET
REMEMBER to turn o power at the breaker.
Follow the steps below to hang your fan properly:
1. Disconnect power to the fan location at the breaker. A licensed
electrician must install the fan.
2. There are four screws on top of the motor assembly. Remove two
that are on the opposite of eachother and save for section 10.
Loosen remaining two.
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in Figure 4.
4. Secure the hanger plate and hanger gasket to the ceiling outlet
box with the screws and washers provided (Fig. 5).
FIGURE 4
FIGURE 5