Installation Guide

FH-W1803
Axis Flush Instructions12
1. Insert the blade through the slot in the housing. Align the holes
in the blade with the fan motor assembly holes and secure with
blade attachment screw with lock washers (Fig. 3).
2. Repeat this procedure with the remaining blades.
3. Attaching the Fan Blades
2. Hanging the Fan
REMEMBER to turn o power at the breaker.
Follow the steps below to hang your fan properly:
1. Disconnect power at the breaker to the fan location.
A licensed electrician must install the fan (Fig. 2).
2. Remove 1 of 2 screws from the bottom of mounting bracket
and save for use in the Finishing the Installation section. Loosen
the other screw (Fig. 2).
3. Pass the 120-volt supply wires through the center hole
in the ceiling mounting bracket as shown in (Fig. 2A).
4. Secure the mounting bracket to the ceiling outlet box with
the screws and washers provided with your outlet box.
5. Secure the safety cable to the building structure using spring
washer, at washer, and wood screw provided (Fig. 2B).
NOTE: Safety cable is required for all installations in Canada. Safety
cable is required for ceiling fan and light combinations over 35 lbs. in
both ush and downrod models in the United States.