Installation Guide

8FH-W1802
6. HANGING THE FAN
REMEMBER to turn o power at the breaker.
Follow the steps below to hang your fan properly:
Motor Assembly
FIGURE 6
FIGURE 5
FIGURE 4
Screws
120V Wires
UL/cUL Listed
electrical box
Mounting Plate
Mounting screws
(supplied with
outlet box
1. Disconnect power at the breaker to the fan location. A licensed
electrician must install the fan. (Fig. 4)
2. Remove 2 of 4 screws from the bottom of mounting bracket and
save for use in section 9. Loosen the other two screws. (Fig. 5)
3. Pass the 120-volt supply wires through the center hole in the
ceiling mounting bracket as shown in (Fig. 5)
4. Secure the mounting bracket to the ceiling outlet box with the
screws and washers provided with your outlet box. (Fig. 6)