Installation Sheet

ManualsBrandsModern Forms ManualsAll Modern FormsModern Forms Wall Mount 6 Speed Smart Ceiling Fan Control with Dimmer and Summer and Winter Mode

PAIRING

If you need to re-pair your fan or you want to pair a second

wall control:

1. Power cycle your fan by turning o the power at the

circuit breaker.

2. Press and hold and buttons on wall control

for 10-15 seconds.

3. The LED will blink green then remain solid green.

4. The green LED along with audible beeps will indicate

that pairing is successful.

5. Test wall control for functionality.

UNPAIRING

NOTE: Purging must be completed within 3 minutes

of turning the power on to the fan receiver.

1. When you re-engage power to the fans you

want to purge, press and hold the and

buttons for 4 seconds.

2. The LED will alternate red/green, blink green,

and the receiver will beep to indicate that purging

is successful.

MULTI LOCATION WIRING

1. Install the wall control using the wiring diagram in section 1.

2. Individually pair each of the wall controls with the fan

receiver using the pairing instructions in section 3.

NOTE: Pairing must be completed within 3 minutes of turning

the power on to the fan/receiver.

FAN WI-FI RESET

NOTE: This function only resets the Wi-Fi credentials.

1. Press and hold the

and buttons for 6 sec.

2. The LED will light red blink green

and return to solid red, and the

receiver will beep to indicate that

Wi-Fi reset is successful.

3. After the Wi-Fi resets, the fan will

broadcast its service set indicator

(SSID).

NOTE: If you are updating your router

the fan will still appear in the Modern

Forms app but will need to be re-paired.

You can change the name of

your fan on the Modern Forms app

upon re-pairing.

Wall Controller 1 Wall Controller 2 Wall Controller 3

Fan

if Applicable

Line/Hot

Red

Neutral/White

Ground (Green or Bare)

FACTORY RESET

NOTE: This will remove wall control and app connections.

Wall Control Factory Reset:

1. Press and hold the , and buttons

for 10 seconds

2. The LED will blink red and return to solid red,

and the receiver will beep to indicate that the

factory reset is successful.

RECEIVER BUTTON FACTORY RESET

1. Press the reset button on the receiver until

the receiver beeps

NOTE: This will remove wall control and Modern Forms

app connections.

Modern Forms App