Installation Sheet

Fan Wi-Fi Reset
NOTE: This function only resets the Wi-Fi credentials.
1. Press and hold the and buttons for 6 sec.
2. The LED will light red, blink green, and return to solid
red, and the receiver will beep to indicate that Wi-Fi
reset is successful.
3. After the Wi-Fi resets, the fan will broadcast its service
set indicator (SSID).
4
5
Factory Reset
NOTE: This will remove remote control and app connections.
Remote Control Factory Reset:
1. Press and hold the , and buttons
for 10 seconds.
2. The LED will blink red and return to solid red,
and the receiver will beep to indicate that the
factory reset is successful.
Receiver Button Factory Reset
NOTE: This will remove remote control and Modern Forms
app connections.
6
Modern Forms App
NOTE: If you are updating your router, the fan will still
appear in the Modern Forms app but will need to be
re-paired. You can change the name of your fan on the
Modern Forms app upon re-pairing.
FIG.6
FIG.7
FIG.8
Press and Hold
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
FCC Supplier’s Declaration of Conformity
Brand name: Modern Forms
Model number: F-RC-WT
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
WAC LIGHTING CO.
44 Harbor Park Drive, Port Washington, NY 11050
Tel: [phone]
Rules and Regulations
CAUTION: The user is cautioned that changes or modifications
not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Press the reset button on the receiver until the
receiver control beeps.
2. Power cycle the circuit to complete the process.