Installation Guide

www.modernforms.com

Modern Forms retains the right to modify the design of our products at any time as part of the company’s continuous improvement program.

F-1811-LED

INSTALLATION INSTRUCTIONS

UNINSTALLING THE DECORATIVE LOWER CAP

Remember to : disconnect the power at the circuit breaker.

1. Unthread and remove the decorative lower cap from the motor

assembly (FIG. 1).

2. Remove the 3 screws from the wire housing lower cover and

keep them for use with the light kit adapter plate. Remove the

wire housing lower cover.

INSTALLING THE LED LUMINAIRE MODULE

1. Raise and hold the LED luminaire module close to the adapter plate

and proceed to secure the wire connections. Connect the white wire

connector from the LED luminaire module to the white wire of the fan.

Follow the same procedure with the black wire connectors (FIG.3).

2. Tuck connections neatly into adapter plate. Using the 3 screws

provided, install the LED luminaire module to the adapter plate (FIG. 4).

3. Raise glass shade up against the luminaire module and secure it to fan

by turning the glass clockwise until snug. Do not over-tighten (FIG. 5).

1. Install the adapter plate to the mounting ring using

FIG. 1

FIG. 3

FIG. 4

FIG. 5

FIG. 2

NOTE: If you plan to uninstall the optional LED light kit,

store the decorative lower cap and wire housing lower cover

in a safe place for later use.

INSTALLING THE LIGHT KIT ADAPTER PLATE

the 3 screws previously removed (FIG. 2).