Installation & Assembly

2Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Cascade - LED Pendant
PD-41719, PD-41728, PD-41737
PREPARATION
1. Shut o the power at the circuit breaker and remove existing xture,
including the crossbar.
2. Carefully unpack your new xture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screws (C1) from the xture.
4. Adjust the xture wire length by pushing the cable gripper on the
canopy and pulling the wire as desired.
5. Connect the driver input wires with junction box wires as shown in
Fig. 2, making sure that all wire connectors (A1) are secured.
If your outlet box has a green or bare copper ground wire, connect
the xture's ground wire to it. Otherwise, connect the xture's
ground wire directly to the mounting plate using the green screw
provided. After wires are connected, tuck them carefully inside
the junction box.
*Requires Driver to be recessed within the junction box.
MOUNTING THE FIXTURE (Fig. 1)
6. Secure mounting plate to the junction box using junction
box screws (B1). The side of the mounting plate marked
"GND" must face out.
7. Place the xture over the mounting plate and secure it with
mounting screws (C1).
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
4 3/4"
1 3/8"
1 3/4"
Back Plate Dimensions
A1
B1
C1
Cable gripper
Push up
Instruction: Adjust the xture
wire length by pushing the
cable gripper on the canopy
and pulling the wire as desired.
Junction Box
Wire Connector
Mounting Back Plate
Driver
Junction Box Screw
Mounting Screw
Lamp Body
Crystal Glass (RPL-GLA-41719)
FIG. 1