Installation Guide

2
INSTALLATION INSTRUCTIONS
249-LED Wall Sconce
BL-24959
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
FIG. 3 Wiring
FIG. 1 MOUNT ON SWITCH BOX
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Modern Forms retains the right to modify the design of our products at any time as part of the company's continuous impro
vement program. Jan 2019
ANUARY, 2017
modernforms.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture,
including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Be careful not to lose any small parts necessary for installation.
MOUNT ON SWITCH BOX (Fig. 1)
3. Remove the mounting screw (D) from the fixture.
4. Secure the fixture tail (E) to screw into the fixture’s tube.
5. Drill holes in the wall aligned with the key holes located in the mounting plate, insert the plastic anchor (C).
6. Connect the driver's (F) input wires to switch box wires as shown (Fig. 1). Make sure that all wire connectors (A) are secure. If your
outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground
wire directly to the mounting plate using the green screw provided. After wires are connected, tuck them carefully inside the switch
box
NOTE: This fixture requires the driver to be recessed in the switch box.
Swit c h Box
Wire Connector
Mounting Plate
Fixture
Fixture Tail
Driver 3 3/8" × 1 3/8" × 1 3/16"
Plastic
A
nch
or
Wood Screw
Junction Box Screw
Mouting Screw
A
B
C
D
E
F
FIG.2 MOUNT ON JUNCTION BOX.
Ground Wire
Junction Box
Mounting Ring
Conversion
P
late
Junction Box Screw
Conversion
P
late Screw
Wire Connector
Driver 3 3/8" × 1 3/8" × 1 3/16"
G
H
A
F
I
Black -
Hot
White - Neutral
Purple - Dim+ Gray
- Dim-
Female End Connector
Fig.4 Driver wires
Female End Connector
Male End Connector